Composition of Standard Electric Care Bed

The standard electric care bed must use the following components:
1. Specification: 2200×900×500/700mm.
2. The whole electric care bed adopts the Swiss "Golden Horse" automatic flow spraying line, which adopts powder electrostatic spraying, with bright color and firm adhesion.
3. The headboard and footboard of the electric care bed is made of imported ABS material by blow molding as a whole, with a smooth surface; the switch is located outside, which can be easily loaded and unloaded, and the headboard card can be inserted.
4. The ABS guardrail adopts a damper device to control the speed and noise, and the nursing staff can easily operate up and down with a small force with one hand.
5. Equipped with φ130 middle control movable casters, high stability linkage system, stable and convenient braking. Caster body adopts aluminum alloy die-casting process, sealed bearing, waterproof, dustproof, double wheel cake design to increase the landing area and increase stability. Polyurethane material does not fade, wear-resistant.
6. Equipped with Danish LINAK safety voltage linear motor, with stable and reliable performance, with battery, continuous power-off work for 4 hours. No noise, long service life, 3 times that of ordinary domestic motors.
7. There are two foldable infusion stand jacks and four drainage hooks on both sides of the bed; there is a washbasin frame under the bed.
8. Various functions can be controlled by hand-held switches: the overall lift is 500-700m; the angle between the back plate and the horizontal plane is 0-70 degrees, the angle between the calf plate and the horizontal plane is 0-20 degrees, and the angle between the thigh plate and the horizontal plane is 0-30 degrees; the bed The overall forward and backward tilt angle of the face is ≥ 12 degrees.
9. The bed surface is made of Shanghai Baosteel Q195 cold-rolled steel plate with a thickness of 1.2mm, which is formed by one-time stamping and has no welding spots on the surface; the frame is made of 1.5mm wall thickness steel pipe, and the carbon dioxide gas shielded welding process is used.

Nursing beds are generally powered beds, which are divided into electric or manual electric care bed. They are designed according to the patient's bedridden living habits and treatment needs. They have multiple nursing functions and operation buttons. It has functions such as back meal, regular turning over alarm, prevention of bedsores, negative pressure suction urine and bedwetting alarm, mobile transportation, infusion administration, related prompts and other functions, which can prevent patients from falling out of bed. Rehabilitation nursing beds can be used alone or in combination with treatment or rehabilitation equipment.