Ways to overhaul baby medical beds

Baby medical bed is a medical bed designed separately for infants, compared with adult beds, it has a strong and durable, beautiful appearance, just corrosion, easy to clean and other advantages, medical staff should use the baby bed for a certain period of time, to overhaul it, to see if there are potential failure problems, many years of experience we can get to overhaul the common four methods of medical baby beds, the following is the relevant content introduction:
1. Mattress from bed and thorough inspection. Look for bedspreads and sagging or bumps that indicate severe wear and tear on the mattress itself. Use an interior needle or an appropriate sewing machine repair cover. If properly disinfected, or replace with a worn-out mattress of the same type, spring, foam or gel. Give fresh cover to new mattress if applicable.

2. Disassembled frame, including armrests, headboard and pedals. Pull off casters, wheels and brakes from every corner of the bed frame. Keep away from rusty areas and all use electric polishers. Protects the primer and then paints the metal parts with the paint. Install new forks and replace worn castors and wheels as needed. Replace the plastic cover on the armrest with a new one.
3. Remove any electronic parts, such as circuit boards and control mechanisms. All electronic surfaces are blown away dust and dirt using compressed or aerosol air. Replace worn cables and wires. Test electronic components such as switches and control buttons, mechanized bed movement. Circuit boards that replace old beds, circuit tests show, electronic components.

4. Reorganize bed frame and related parts. Lubricate all frames on the chain, including all movable joints. Swivel joints to ensure they run smoothly and don't squeak and glide. Attach new or clean electronic components, switches and wiring. Place on a new or refurbished mattress. The function of the power cord and test bed that plugs into the power outlet.

In addition, during the use of medical baby beds, please do not overload use, to prevent strong shock, vibration, extrusion, etc., safe load static 250kg; Dynamic 170kg, regular joint examination of the active part (the cycle is generally once a quarter) (such as screw solid parts, lubricating oil addition), avoid the use of contact with strong acid, alkali, salt items, cleaning should be wiped with low-concentration detergent, and then wet with water towel twisted and wiped clean.