Matters needing attention when using controllers for electric hospital beds

The working principle of the electric hospital bed: After the drive motor in the electric push rod is decelerated by the gear, it drives a pair of screw nuts, converts the rotational motion of the motor into linear motion, and uses the positive and negative rotation of the motor to complete the push rod action. The push rod realizes various actions of the electric hospital bed through actions of mechanisms such as various levers and rockers.

1. Before using the multifunctional electric hospital bed, first check whether the power cord is firmly connected. Whether the controller line is reliable.
2. The wires and power wires of the controller's linear actuator must not be placed between the lifting link and the upper and lower bed frames, so as not to cut the wires and cause personal equipment accidents.
3. After the backboard is raised, the patient lies down on the panel and is not allowed to push it.
4. People cannot stand on the bed and jump. When the backboard is raised, people are not allowed to push when sitting on the backboard or standing on the bed panel.
5. After the universal wheel is braked, it is not allowed to push and move, and it can only be moved after releasing the brake.
6. It is not allowed to push horizontally to avoid damage to the lifting guardrail.
7. Uneven roads cannot be used to prevent damage to the universal wheels of the multifunctional electric medical bed.
8. When using the controller, the buttons on the control panel can only be pressed one by one to complete the action. It is not allowed to press more than two buttons at the same time to operate the multifunctional electric medical bed, so as to avoid malfunctions and endanger the safety of patients.
9. When the multifunctional electric hospital bed needs to be moved, the power plug must be unplugged, and the power controller wire must be wound before being allowed to move.

10. When the multifunctional electric hospital bed needs to be moved, the lifting guardrail should be lifted to prevent the patient from falling and being injured during the movement. When the electric bed is moving, two people must operate it at the same time, so as not to lose control of the direction during the pushing process, causing damage to the structural parts and endangering the health of the patient.