How to choose the right ICU electric hospital bed？

Nowadays, the equipment in the intensive care unit of the ICU is getting more and more attention. A good equipment can bring a better medical experience to the patients and improve the work efficiency of the nursing staff.
So how to choose a qualified and reliable ICU electric hospital bed has become a crucial issue. We need to start from the following aspects:
1. The purchase of an ICU intensive care bed first depends on whether the raw materials are qualified. The other party must be required to have complete relevant documents, and the manufacturer's raw material procurement must be well documented.
2. Secondly, we should look at the related process problems in the production of electric hospital beds. According to relevant regulations, a strict rust removal process should be carried out on the steel pipes of electric hospital beds. If this process is not strictly operated, the service life of the electric hospital beds will be seriously reduced.
3. For the spraying work of the electric hospital bed, according to the relevant regulations, the electric hospital bed must be sprayed three times. This is to ensure that the sprayed surface can be firmly attached to the surface of the electric medical bed and will not fall off in a short time.
4. The back of a good ICU electric hospital bed adopts a double support structure, with sufficient support strength to ensure patient safety; three types of casters (common wheel, central control wheel, fully enclosed wheel) are designed, which should be able to brake and have good stability. Different ward requirements can be met:
5. Select brand motors to fully ensure the safety of the motor system.
6. There is a relatively complete intelligent control system. The entire nursing bed contains several independent mechanisms under the mechanism structure. Each mechanism corresponds to more than one degree of freedom. These mechanisms are coordinated by the overall control system. Under the control of withering, a multi-open chain system is formed, and through the movement of each bed panel, the hospital bed can complete a specific posture.

The ICU intensive care bed produced by the medical bed manufacturer shall meet the standards and be manufactured according to the drawings and documents approved by the prescribed procedures. The bed surface of the ICU electric hospital bed is made of steel plates, steel slats, steel wires, galvanized iron wires, wooden boards, wooden slats and other materials. The welding seam of the hospital bed should be uniform, and there should be no defects such as burning, cold cracking, and missing welding. After the bed and the bed are assembled, they should be firmly fixed and not loose. Each time the foot frame is adjusted by one gear, the drop groove of the support frame should be accurate and reliable, and there should be no slipping phenomenon. The bed surface of the hospital bed should have good ventilation. Attachments such as bed rails and infusion stands can be installed on both sides of the bed frame. If the bed is installed with casters, there should be brakes. The casters or foot protectors of the hospital bed should be firmly assembled with the foot of the bed.