How to install a medical bed?

Many customers do not know how to install a medical bed after purchasing it. Next, the manufacturer of the medical bed will introduce the specific installation method to you.
The first step is to install the screw. When the lead screw is installed, pay attention not to screw on the handle end too tightly, so as not to affect the abnormal application of the lead screw. If the reserved hole is not accurately connected at the connection between the end of the lead screw and the bed surface, it is necessary to transfer the lead screw for a few turns. , until the reserved holes are in the same straight line, the tail of the lead screw adopts a locking nut, so that the nut can be fastened to a quarter of the screw, and the lead screw connecting plate and the tail of the lead screw cannot be completely tightened together.
The second step is the bed leg device. First insert the bed legs until the reserved bed legs are inserted and released, take out the larger screws in the screw box, and fasten them from the inside to the outside. After the legs are installed, turn the bed over to the side.
The third step is to install the guardrail, put the control part of the guardrail handle at the end of the bed, aim at the 3 reserved screw holes, take out the corresponding screws, and fasten them from the outside to the inside.
The fourth step, bedside device, take out two bedsides, one high and one low, the high one is for the head, and the low one is for the tail, close the bedside safety pin corresponding to the two card slots, and lock the safety pin after setting it aside.
The fifth step, take out the mattress, and lay the quilt flat against the bed.
The sixth step, take out the table board, stretch the two ends to a suitable position, and place it on the guardrail.

The seventh step is to take out the infusion stand and insert it into the reserved infusion stand hole at the head of the bed. During the application of the special care bed, the back can be raised up to 80 degrees, and the legs can be lifted outside the legs. In the semi-curved state, the crank handle can be pulled outwards and retracted downwards without compromising the maintenance work around the bed.