Causes of common failures of medical electric hospital beds

(1) The medical electric hospital bed has air bubbles, residual dust, and local stains. The reason for the occurrence of inoculation: The uneven resin on the production workers causes the occurrence of the separation of the fiber mat, and the work is too fine and not carefully formed. Treatment method: Strengthen work responsibilities, work full-time and dedicated, and implement it to people.
(2) The mold clamping part of the medical electric hospital bed is bumpy. The reason for the occurrence of gestation: the grinding staff did not work carefully. Treatment method: Strengthen the sense of responsibility of the grinding workers, and follow the standard grinding operations during specific operations.
(3) The collective color tone of the medical electric hospital bed is uneven and there is color difference. Causes of inoculation: Surface damage caused by mucous membranes when the product is demolded. The product clamping seam is too large to be trimmed. Treatment method: When the product is produced, the workers must apply wax evenly on the surface of the mold, and work too finely to ensure that the surface of the mold is evenly spread. Trim production mold, strengthen production and demoulding process.
(4) The positioning of the holes is not accurate, and the bolts are not installed smoothly. The reason for the occurrence of gestation: the personnel were not carefully assembled. Handling steps: Strengthen work responsibilities, work full-time and dedicated, implement it to people, and ensure accurate positioning.
(5) The placement of the foot support holes is not smooth. The reason for the occurrence of inoculation: There is no cleaning in the settling hole, and there are residues on the screw holes of the pre-embedded screws. Compensation method: clean up the settling holes and pre-embedded screw thread residues. Each set of Mingtai medical electric hospital bed must be smoothly assembled once with each accessory.

(6) The strength of the connection between the metal embedded parts of the foot support tray and the fiber is not good, and it is a defective product if it cannot withstand the pressure of 20KG. The reason for the occurrence of pregnancy: the plan is unreasonable. Treatment method: Remake the mold to accept a new production plan.