Restoration of electric hospital beds

1. Electric hospital bed mattress and thorough inspection. Look for bedspreads and sagging or unevenness that indicate severe wear and tear on the mattress itself. Use an upholstery needle or appropriate sewing machine repair cover. If properly disinfected, or replaced with a worn-out new mattress of the same type, spring, foam or gel. Give a new mattress a fresh cover if applicable.
2. Disassemble the frame of the electric hospital bed, including the armrest, headboard and pedal. Pull off castors, wheels and brakes from every corner of the bed frame. Keep away from rusty areas all use an electric polisher, protect the primer, and then paint the metal parts with a final layer of paint. Install new forks and replace worn castors and wheels as needed. Replace the plastic cover on the new armrest.
3. Remove any electronic parts, such as circuit boards and control mechanisms. All electronic surfaces use compressed or aerosol air to blow away dust and dirt. Replace worn cables, wires and wires. Test electronic components such as switches and control buttons for mechanized hospital bed motion. Circuit tests that replace old beds of circuit boards show that electronic components.

4. Reorganize the bed frame of the electric medical hospital bed and related parts. Lubricate the frames on all hinges, including all movable joints. Swivel joints to keep them running smoothly and not squeaking. Attach new or clean electronic components, switches and wiring. Place on a new or refurbished mattress. Plug into the power cord of the electrical outlet and the function of the test bed.