How to Install and Use Home Nursing Bed

How to install and use home nursing bed
1. There are two casters with brakes. Install the two casters with brakes in the screw holes on the legs of the bed frame diagonally; then install the remaining two casters on the other two legs. in the screw hole.
2. Installation of the back bed surface: Connect the back bed surface and the bed frame with the back frame pin, and then lock the pin with a split pin.
3. Installation of the head of the bed: Insert the head of the bed into the holes on both sides of the back bed, and tighten the fastening screws on both sides.
4. Installation of the back position gas spring: push up the back position bed surface to a 90-degree angle, screw the end of the back position gas spring with the screw into the gas spring support seat at the bottom of the back position bed surface, and then lower the gas spring to the support seat Connect it with the U-shaped frame of the bed body with a pin, and then use a split pin to lock the pin.
5. Installation of the side gas spring: The installation of the side gas spring is the same as the installation of the back gas spring. Just lift the side bed surface lightly, and press the U-shaped pin on the lower support seat of the side gas spring and the bed body. The shaft is connected, and the pin is locked with a cotter pin. Then press the side control button to place the side bed surface in a horizontal position.
6. Installation of the foot bed surface: first turn the foot bed surface over, connect the hole tube and the support seat on the hole tube with a pin shaft, and lock it with a split pin. Then turn the screws on both sides of the hole tube sliding sleeve bracket, align the holes on both sides of the hole tube sliding sleeve with the screws on the bracket, and tighten the screws with a wrench. Pick up the connection hole between the foot bed surface and the thigh bed surface and thread it with the foot frame pin, and then lock it with the cotter pin.
7. Installation of foot guardrail: Fasten the two foot guardrails into the installation holes on the footbed surface respectively, and then put on the screws and tighten them.
8. Installation of seat belt: Take out the seat belt, bypass the cushion on the head bed, and pass through the two limit holes on the back of the head bed.